Microsoft Knowledge Base Article
This article contents is Microsoft Copyrighted material.
©2005-©2007 Microsoft Corporation. All rights reserved.
Terms
of Use |
Trademarks
Article ID: 154030 - Last Review: July 15, 2004 - Revision: 2.2
INFO: Configuring SNA Server for Use w/ an Attachmate Twinax Adapter
This article was previously published under Q154030
This article describes how to configure the Attachmate Advanced Twinax
adapter for use with SNA Server.
The Attachmate Advanced Twinax Adapter needs to be configured as an IBM
Twinax adapter because it is register compatible with the IBM 5250 Enhanced
Emulation Adapter. SNA Server needs to be configured to use the IBM Twinax
Link Service when the Attachmate Advanced Twinax Adapter is used. SNA
Server's IBM Twinax Link Service requires that the following parameters
match those that are configured on the Twinax adapter:
- Interrupt
- I/O Address
- Page Address
The IBM Twinax Link Service supports I/O addresses of 2xxA, where xx is a
value from 40 to 7F. The Attachmate Advanced Twinax Adapter has valid I/O
addresses that range from 2418-241F to 27F8-27FF. The valid I/O addresses
for the Attachmate Twinax adapter do not appear to match the valid I/O
addresses for the IBM Twinax Link Service because they do not end with a
hexadecimal 'A', so it is not apparent how to configure the I/O addresses.
When you configure the IBM Twinax Link Service for use with the Attachmate
Twinax adapter, select an I/O Address that matches the first three
hexadecimal values of the I/O Address configured on the Twinax adapter. For
example, select an I/O address of x'241A' in the IBM Twinax Link Service
configuration if the Attachmate Twinax adapter is configured to use an I/O
address range of x'2418' - x'241F'.
APPLIES TO
- Microsoft SNA Server 3.0, when used with:
- Microsoft SNA Server 2.11 Service Pack 1, when used with:
- Microsoft SNA Server 2.11 Service Pack 2, when used with:
- Microsoft SNA Server 3.0 Service Pack 4, when used with:
- Microsoft SNA Server 4.0, when used with:
- Microsoft SNA Server 3.0 Service Pack 2, when used with:
- Microsoft SNA Server 3.0 Service Pack 3, when used with:
- Microsoft SNA Server 4.0, when used with:
- Microsoft SNA Server 4.0 Service Pack 1, when used with:
- Microsoft SNA Server 4.0 Service Pack 2, when used with:
Community Feedback System
Very often, it takes hours to solve a problem. Very often, you've looked high
and low, and have tried a lot of solutions. When you finally found it, chances
are, it was because someone else helped you. Here's your chance to give back.
Use our community feedback tool to let others know what worked for you and what
didn't.
Please also understand that the community feedback system is not warranted to be
correct, it's simply a system that we've built to let people try and help each
other. If something in a feedback response doesn't make sense to you, or you're
not comfortable making changes that the feedback talks about (like registry
edits), please consult a professional.
Thank you for using kbAlertz.com Feedback System.
-- Scott Cate